PRO-625W Parts Adjustment

Parts adjustment for conveyor adjustment, conveyor height adjustment, wrap around belt adjustment, and label press piece adjustment

1. Conveyor adjustment: To adjust the tension of the conveyor belt, loosen the two nuts on the screws. Turn counter clockwise to loosen and clockwise to tighten. Make sure the conveyor is centered to reduce any noise. See A.
   
   

2. Top hold down belt adjustment: To adjust the tightness and centering the belt, adjust the adjustment screw. When adjusting, use only small increments and let the belt run for a while to determine the final position.
   
   

3. In adjusting the side pressure’s roller chain, there is 1 place to adjust screw A. When adjusting A , the 2 screws must be adjusted evenly and must check if the degree of tightness is the same. Another thing to check is if the side pressure’s roller chains are paralell with each other. If the rollers are not level, the bottles will not be oriented properly. It is important for the rollers to be leveled.
   
   

4. Label press piece adjustment: First, loosen screw (A) turn the rod (2) counter clockwise and hold it. Use your other hand to tighten screw A and then release it.
   
   

5. Wrap around station adjustment:

A	Wrap Around
B	Pressure Plate
C	High & Low Adjust
D	High & Low Adjust
E	Frontward & Backward

1. 1. To adjust wrap around station height: only adjust screw C and D so you can adjust wrap around belt and pressure plate height.
      
      

1. 1. To adjust wrap around station widths: As follow drawing show, put object between wrap around belt and pressure plate. Adjust frontward and backward screw E, let pressure plate press object with suitable pressure. Then turn on conveyor to check object and be turned smoothly.
      
      

6. Wrap around belt adjustment: To adjust the tightness and centering the belt, adjust the screw A. When adjusting, use only small increments and let the belt run for a while to determine the final position. A belt that is not centered will slip up or down.