PRO-515 Label Applicator

Follow these instructions to insert the labels into the label applicator

1. Place the label roll on the supply plate and pass the labels around the tension roller to control over rotation of the roll.
2. Secure the labels by adding tension to the label press pad. This will prevent the labels from running loosely.
3. If a printer is installed, pass the labels between the print head and the print pad of the printer.
4. It is important for the labels to pass through the forks of the label sensor and make contact with one side. The label sensor controls the dispensing of the labels.
5. The PU drive roller pulls the base paper to apply the labels. The aluminum knurled roller must be closed and locked in place with the PU drive roller in order to squeeze the paper and pull effectively.

WARNING: If the aluminum knurled roller is not tightly pressed against the PU drive roller, the labeling will be inaccurate, which will cause incorrect labeling. If the aluminum knurled roller is pressed too tight, it will cause the PU drive roller to wear and crack.

6. Wind the base paper around the 3 pillars at the collection of the base paper. Wind it up until there is some tension on. The paper for proper pickup.